Radiofrequency
Radiofrequency — Skin Tightening Pass
Cosmetic appearance of firmer, smoother-looking skin over a series of sessions.
What am I doing?
An applicator that warms the skin surface and underlying tissue as part of a cosmetic firming service.
Where am I doing it?
Abdomen · Flanks · Upper arms · Thighs
How do I do it safely?
Light, even contact. Heat comes from the device, not from pressure.
What do I do next?
Document the session, give aftercare and set the follow-up.
Movement pattern
Keep the handpiece moving — slow, overlapping, continuous.
- 1Small work zone. Treat one small zone at a time rather than the whole area.
- 2Continuous sweeps. Slow overlapping sweeps; never park the head.
- 3Monitor warmth. Ask about comfort often; warmth should be comfortable, never sharp.
- 4Hold the zone. Maintain the zone only for the approved duration, then move on.
Technique demonstration
Video placeholder — your instructor uploads the approved demonstration for this modality here.
Manufacturer / Instructor Approved Settings
Left intentionally blank. Only your instructor or administrator fills this in for your specific machine.
Intensity / power level
To be entered by instructor / administrator
Duration per area
To be entered by instructor / administrator
Frequency / mode
To be entered by instructor / administrator
Sessions per week
To be entered by instructor / administrator
Notes from instructor
To be entered by instructor / administrator
Set up
Supplies needed
Conductive gel or approved slip medium · Infrared thermometer if used in your training · Clean towels · Disinfectant wipes
Client positioning
Comfortable, draped, skin dry before gel. Keep the area accessible without the client holding a pose.
Provider positioning
Close enough to keep continuous contact with a relaxed wrist; the return plate placed as taught.
Handpiece positioning
Flat, full contact, continuous movement. Warmth should build gradually and evenly.
Areas to avoid
- Over implanted electronic devices or metal
- Thyroid, throat, eyes and genitals
- Numb areas or areas with reduced sensation
- Recent injectables or procedures unless cleared
- Any area excluded by your instructor or the manufacturer
Common beginner mistakes
- Chasing a temperature number instead of following approved protocol
- Treating dry skin without enough slip medium
- Ignoring a client who says the heat is sharp
- Working over an area with reduced sensation
Safety reminders
- Comfortable warmth only — sharp heat means stop and reassess.
- Never treat over areas where the client cannot reliably report sensation.
- Document tolerance and skin response every session.
Stop
Stop treatment if any of the following happen: Sharp or increasing heat; Blanching, welts or unusual redness; Client anxiety or discomfort; Device fault or applicator damage. Do not resume until the situation has been appropriately evaluated.
Documentation reminders
- Zone treated and duration
- Approved settings used
- Client tolerance
- Skin appearance before and after
Aftercare considerations
- Use the instructor-approved aftercare for RF.
- Common themes: sun protection, gentle skincare, hydration.
Mini quiz
The client describes the warmth as a sharp, pinpoint burn. What now?
Educational use only. SculptCoach does not diagnose conditions and does not replace manufacturer instructions, professional training, state or local requirements, or medical advice. Always follow the settings and protocols approved by your instructor and your device manufacturer.